Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

drkidd22 · 04-09-2009, 10:43 AM

I was having the same problem, so what I did was:
Replace clutch master
Replace Slave
Bypass Damper
BLEED it REALLY GOOD.

But in your case you say the slave is pushing the plate and releasing fine, so make sure it is being pushed all the way back when you put your foot on the clutch and that it releases smooooothly when you take the foot off the pedal, you will need someone to press/release the clutch for you. You can try putting your car in gear, lets say 2nd, and try to push your car (without the clutch pedal being pressed) if your car moves then you have a clutch that's fully relased and not engaging. So next part is take your tranny out and fix it.

Good Luck!

04-09-2009, 10:43 AM	#2
drkidd22 BANNED Join Date: Jun 2007 Location: USA Age: 39 Posts: 146 Trader Rating: (0)	I was having the same problem, so what I did was: Replace clutch master Replace Slave Bypass Damper BLEED it REALLY GOOD. But in your case you say the slave is pushing the plate and releasing fine, so make sure it is being pushed all the way back when you put your foot on the clutch and that it releases smooooothly when you take the foot off the pedal, you will need someone to press/release the clutch for you. You can try putting your car in gear, lets say 2nd, and try to push your car (without the clutch pedal being pressed) if your car moves then you have a clutch that's fully relased and not engaging. So next part is take your tranny out and fix it. Good Luck!