Thread: S14 belts in S13, B pilalr plastic WILD! show me!
View Single Post
Old 04-14-2009, 05:48 PM   #7
MrMcgarrett
Post Whore!
 
MrMcgarrett's Avatar
 
Join Date: Sep 2006
Location: Pomona, CA
Age: 43
Posts: 5,591
Trader Rating: (313)
MrMcgarrett is close to perfectionMrMcgarrett is close to perfectionMrMcgarrett is close to perfectionMrMcgarrett is close to perfectionMrMcgarrett is close to perfectionMrMcgarrett is close to perfectionMrMcgarrett is close to perfectionMrMcgarrett is close to perfectionMrMcgarrett is close to perfectionMrMcgarrett is close to perfectionMrMcgarrett is close to perfection
Send a message via AIM to MrMcgarrett
I used a Z32 upper mounting bolt and added two washers equaling about 1/4in.

I made a 3/4in hole under the middle mounting tab on the back of b pillar plastic then shaved off the mounting tab.

Total cost: $0
MrMcgarrett is offline   Reply With Quote