|
that's really neat.
From what I gather (and please correct me if I'm wrong), you can achieve the same effect via:
- moonface roll center adjuster ball joints for the flca
- kazama outer tie rod which has spacers so you can stack depending on how low you are.
Seems like a more affordable/readily available solution to me. The advantage of the unit you posted is that you don't need to use spacers on the tie rod ends & you have more customization w/ the spacers for the knuckle vs. the default spacing on the ball joint adjuster.
On a side note: how did you like the rear roll center adjusters? I was contemplating about getting these, but I didn't really see them as help all that much - from what I saw, it will only lower the rear lower control arm & sway bar while all other arms are still angled.
|