Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

BoostedAuto · 05-10-2009, 04:44 PM

Im getting ready to kill this new 240!!!

Car wont start and or crank.

1.) Problem Bleeding the clutch.
~Previous owner never told me there was a 5-spd swap in the works. Bought an Agency steel braided clutch line. Been trying to bleed the system for the past 2 days, still nothing. Bench Bled the Clutch Master Cylinder, Bled again nothing.

2.) Engine Body Harness.
~Removed it to re-paint my engine bay. After I Installed it theres one connector I have no clue where it goes. Its a white connector that goes through the firewall on the passenger side. Theres 3 connectors at the end of the harness. Been fishing my hand around inside, cant see or find anything.

3.) No Crank, No Start.
~Swapped over my SR from my old S13. Pretty sure its due to problem #2 but if not, ill be bitching

4.) Reverse Lights not working:
~I finished the 5-speed swap but Im kind of iffy on it. I used How To: 5 Speed Swap in Convertibles (and other S13s): 240SX Convertible Forum: Nissan Forums / Infiniti Forums - NICOclub as refrence and after completion, still nothing. I didn't connect the brn/ylw wire to the grn/blu wire due to the fact I believe that is for convertable's to make the top function. Correct me if Im wrong.

5.) Pass rear wheel unable to move.
~I did a 5-lug swap since I upgraded to Z32 brakes. The night I put it on, wheel spun freely, next day it doesn't budge. I haven't pulled it apart yet. Possibly be the z32 backing plate be slightly off??

Pretty sure that covers most of it....Any help would be greatly appreciated!

05-10-2009, 04:44 PM	#1
BoostedAuto Leaky Injector Join Date: Aug 2006 Location: Cleveland Ohio Posts: 126 Trader Rating: (5)	Questions reguarding my S13..=( Im getting ready to kill this new 240!!! Car wont start and or crank. 1.) Problem Bleeding the clutch. ~Previous owner never told me there was a 5-spd swap in the works. Bought an Agency steel braided clutch line. Been trying to bleed the system for the past 2 days, still nothing. Bench Bled the Clutch Master Cylinder, Bled again nothing. 2.) Engine Body Harness. ~Removed it to re-paint my engine bay. After I Installed it theres one connector I have no clue where it goes. Its a white connector that goes through the firewall on the passenger side. Theres 3 connectors at the end of the harness. Been fishing my hand around inside, cant see or find anything. 3.) No Crank, No Start. ~Swapped over my SR from my old S13. Pretty sure its due to problem #2 but if not, ill be bitching 4.) Reverse Lights not working: ~I finished the 5-speed swap but Im kind of iffy on it. I used How To: 5 Speed Swap in Convertibles (and other S13s): 240SX Convertible Forum: Nissan Forums / Infiniti Forums - NICOclub as refrence and after completion, still nothing. I didn't connect the brn/ylw wire to the grn/blu wire due to the fact I believe that is for convertable's to make the top function. Correct me if Im wrong. 5.) Pass rear wheel unable to move. ~I did a 5-lug swap since I upgraded to Z32 brakes. The night I put it on, wheel spun freely, next day it doesn't budge. I haven't pulled it apart yet. Possibly be the z32 backing plate be slightly off?? Pretty sure that covers most of it....Any help would be greatly appreciated!