lol johnathan. its cast iron foo
so yeah here are the pics that this thread is worthless without
step by step of what i did:
1. took off the nuts that secured the top half (as i call it) of the compressor housing.
2. after i got the top part off, i had to unscrew this nut. See how it has a thread on the nut itself (which is 11mm) and the u can secure the bottom portion (9/16"). That came off with some force but rather easily.
3. after that, i got the bolts that secured the lower part of the housing to the mid section and took the lower part off completely.
4. Now on the exhaust side, i unbolted these bolts, but the turbine side doesn't even move
5. So here is where i'm stuck. This is the nut for the turbine side. U can see there is some threading on the shaft to press against, the only thing is, i can't access it as easily as i could with the compressor side. A 15mm fits nicely over the triangular nut, but how to secure the lower side i have no clue
i could secure the shaft on the other side, but its too far away, i'm afraid the twisting might snap it. So any ideas, or advice? Thanx.
