I did a search, but couldn't locate any information on this subject. I am in almost done w/ my sr swap and since I got the whole rear subframe assembly w/ my front-end clip I was swapped in the VLSD unit and anti-sway bar. The only problem is the passenger side output shaft from the differential has a slice in the boot closest to the tire. I was wondering if anybody had any info or part numbers on which output shaft I could use. It has a five-bolt pattern similar to the 300zx shaft, not like the 6-bolt pattern the 240 has. the picture from
link shows the 240 half shaft and 300 half shaft. I'm pretty sure I can just switch the output flanges, but I would like to just swap the shafts, since I have the diff already in.
Sorry for the long post, and thanks in advance,
Bill