Quote:
Originally Posted by fromxtor
I vote
 |
^^^ get one they are worth it.... you can get one for as cheap as $150 and they can go up to $500 for a good one. First off does your dirver door close good? How did you get this dent? Aslong as you didnt get hit from behind and made this dent then dont worry about it, just get yourself one of these stud welders and pop it out. Honestly no need for over fenders. Honestly its not a hard fix. Im not sure if there is access through the inside of the quarter panel to pop it out as much as possible.. but if not this stud welder will do the job just find. Just weld a few studs on there pull dent out as much as possible, then some body filler block smooth, spot prime, spray a guide coat and block again and your done. Too bad your not located here in cali, wouldnt mind helping out a zilvian. Good luck bro.... honestly just fix it no need for over fenders.