|
Ok so I just typed up an entire how-to on removing your door panel. After typing a paragraph and a half for 15 minutes and then accidentally erasing it, I'll make it simple this time.
1) Remove the 3 screws on the bottom of the door panel
2) Remove the screw in the door latch well
3) Pop plastic cap in door handle/grip and remove that screw
4) Pop the round plastic plug at the rear of the door panel, near the top
5) Unclip the connectors from under the window switch tray
Note: On the underside of the window switch tray will be the aforementioned white box, which is your window amp. Take this apart if you wish to inspect it.
6) Grasp the bottom of the door panel and start pulling outward firmly
*be careful not to break the shit out of your door panel!!
7) Once the panel feels loose, pull up and out and it comes off.
Once your door panel is off you can check out all the wiring and the window motor inside the door.
Don't worry about the veterans like projectRDM, they've just been around the block a few times so they've seen a lot (if not everything). Shit with 12,000+ posts to his name, I bet he's seen this at least a couple hundred times!
|