Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - Pulled 17 CEL today.... Jesus Christ. And the car runs fine.....

stunnaben · 12-07-2009, 09:46 PM

So I pulled the following codes from my car today and my car runs fine. Burns a ton of gas but other than that.....

P0100 MASS AIR FLOW SEN*3
P0325 KNOCK SENSOR
P0450 EXAP SYS PRES SEN
P0105 ABSOL PRESS SENSOR
P0443 PURG CONT/V & S/V
P0141 REAR 02 SEN HEATER
P0446 VENT CONTROL VALVE
P1400 EGRC SOLENOID/V
P1105 MAP/BARO SW SOL/V
P1441 VC/V BYPASS/V
Trying to find a way to get these off my ECU and to keep them off. I didn't reset it so I'm sure that will take them away, but since I no longer have any of the EVAP stuff and the EGR stuff how do I trick the ECU into thinking that I have that stuff and the car is working just fine?

12-07-2009, 09:46 PM	#1
stunnaben Zilvia Addict Join Date: May 2009 Location: Houston, TX Age: 35 Posts: 969 Trader Rating: (4)	Pulled 17 CEL today.... Jesus Christ. And the car runs fine..... So I pulled the following codes from my car today and my car runs fine. Burns a ton of gas but other than that..... P0100 MASS AIR FLOW SEN*3 P0325 KNOCK SENSOR P0450 EXAP SYS PRES SEN P0105 ABSOL PRESS SENSOR P0443 PURG CONT/V & S/V P0141 REAR 02 SEN HEATER P0446 VENT CONTROL VALVE P1400 EGRC SOLENOID/V P1105 MAP/BARO SW SOL/V P1441 VC/V BYPASS/V Trying to find a way to get these off my ECU and to keep them off. I didn't reset it so I'm sure that will take them away, but since I no longer have any of the EVAP stuff and the EGR stuff how do I trick the ECU into thinking that I have that stuff and the car is working just fine?