Quote:
Originally Posted by codyace
be careful about over extending the rod, as it can push the pressure fingers 'to far' and into the disc itself, makign an awful screeching noise.
|
I never had this problem on my SR, although slave cylinder travel may depend on the way the clutch is set up.
I usually back the pushrod out until the pedal hits the backstop with about 2-3 turns showing on the pushrod. It should help with bleeding since you have more pedal travel.
After that screw the pushrod in so suit the engagement point and put the stopper bolt/ASCD cancel switch to hold the pedal when it retracts.