Just finishing up a harness relocation on a 1995 S14 5spd.
I unhooked everything in the pedal bay / steering column from the harness with the white Super Junction connector on it. Then I pulled the harness through the firewall, and then through the fender hole and routed it inside the engine bay.
After I relocated it and pulled it back through the firewall into the pedal bay I start hooking up the connectors and now I'm left with this dangling 2 wire connector. It branches off the harness right near where the big white Super Junction connector branch and it has a blue two prong connector at the end. The wire colors are Green/white stripe and black.
Here is a pic of it (I looped it back up and held it with those thick grey wires so it would be in the pic).
Where should it connect? or is it left unconnected?