Quote:
Originally Posted by C-unit
I just encounter some problem. I took the bolts out but the face is not coming out. I can't tell if the face is welded on or just pressed in? Is there any way I can take the face out without scratching it??
|
375-400 degress
15mins
cardboard
a wooden step you can set it on (use a wood plank if you don't have one).
kick in the back of the face until it pops out!
Basically if the step was looked at as a L shape, with the bottom line being the flor and the top of the step not being pictured you just lean the wheel against it like so:
L\
Haha, that's the best I can do!
I didn't care how mine looked afterward because I was redoing everything. You may want to do your temperature at 300-325 degrees and just keep checking it if you're worried about the paint and make sure you are kicking the face out onto something that will not damage it. I had some wooden stairs coming off a deck into the side yard. The grass died there but the wheel was fine, haha.