Quote:
Originally Posted by Press
I was suggested to change my rotors, warped rotors due to heavy breaking is what I've been told. I get the same thing around 50mph, the tires were balanced by the previous owner of the car, but as for the other fixes suggested I'm starting with my rotors ( already have a set of them ). Try rotors if you are able to get some.
|
Its not the rotors i have no shaking while braking or anything.
Quote:
Originally Posted by slider2828
Front Subframe nuts.... That pissed me off so long where I couldn't figure it out.... Check your front subframe bolts make sure they are torqued to the frame. The bolts that extend from the frame might even spin while you are torquing the nuts so keep an eye out for that....
Take a picture of your rack bushings, there maybe excessive space between the triangular part and the clamp... And make sure both clamps are at 80 ft/lbs of torque as per fsm. You can easily check this symptom by raising the front end and have a buddy turn the wheels lock to lock. If there is any movement what so ever, its the rack bushings and the clamps.....
|
This i will check i'm hopeful that this is it, and i already tightened my tensioner quite a bit.
Quote:
Originally Posted by s13bdafocker
only thing i can think of.. drive shaft carrier bearing
|
I have a new 1 piece driveshaft.
Quote:
Originally Posted by ericcastro
I still think its that original thing, and you need to order it and fix it.
not a bad 2nd.
get under there and look at the carrier boot.
Is it intact or fucked? lol
Its in the neighborhood of $100 to do, so you better make sure before you just start replacing shit "because" it could be it.
Really, that nissan statement says EXACTLY what your asking and symptoms.
Most of us have had it.
Have you not replaced it?
|
I understand that it could still be the original thing but i'm waiting on nissan to call me and tell me that the part is in and i can pick it up. This isn't a shimmy though like the TSB describes. This is near violent. Plus when i tightened the spring down thats in there there was no change what so ever.
Quote:
Originally Posted by sliptones629
check you tension rods. Mine would come and go and I couldnt figure it out. One of the aftermarket tension rods was loose. Been fine ever since. Cant hurt to check it.
|
I'll triple check it. although i did re-tighten a bunch of times and also had an alignment done.