Quote:
Originally Posted by midnight_rex
wow so wiring was the main issue. i know there is more than one wire for the 1 degree signal. isnt there 2 more wires that are similar to it? i dont think i have the other 2 wires hooked up in the harness. i just took them out since they were never used. i only have the 1 degree signals wired up. i hope i dant have a issue.
good to hear you fix the problem mike. keep us updated!
|
if you have an s13 motor than the wires you need hooked up are as follows
#30 ecu pin white cas180 degree signal wire
#31 ecu pin black cas1 degree signal
#22 ecu pin white cas180 degree signal
#40 ecu pin black cas1 degree signal
you HAVE to have these wired in correctly. there are 4 wires that are in the cas plug and six that go into the ecu. the black and white ones in the pins mentioned above are split about 6 inches from the blue ecu conector. hope this helps.
as a quick update, i just got a map back from haltech that eric modified for me so im going to try that in a bit.
mike