[drift freaq]

These are high durometer polyurethane engine mounts. The mount bolts do not run straight through the Urethane .

This is done so as to prevent vibrational transfer that you would get with straight through side to side stud.

On top of that these are not tubes of Polyurethane! They are a molded setup using Polyurethane you cannot buy at Home Depot aka the industrial window caulking, which is inferior!

These can lower you engine up to 3/4 of inch depending on how you position them. You can also shift your engine backwards or forwards.

They have been track tested and run on many cars.

The maximum amount is achieved when the offset bolts are placed on the outside with the centered bolts on top.

There is a tech review of them as well here. http://zilvia.net/f/tech-talk/317539...ml#post3416846



It is highly recommended that you use the factory heat shield from your stock mounts on the exhaust side of the engine, especially if you are running a Turbo!

The Group buy price is $110 per set with $15 for shipping anywhere in the continental U.S.

This group buy will require a 10 person buy in to get this price. So lets get this party started.

I decided to add this. If you do not care about the $10 discount you can buy immediately at the $120 per set price which means $135 shipped. my paypal is [email protected]