Quote:
Originally Posted by msanchez
Im making my tubs right now for my s14, and i cant figure out how to make the skirt (flat metal closest to the hot pipe on the driver side and cold pipe on the passenger) meet up flush with the frame rails. I have the top of the tub sitting in about the same spot on the shock towers as all the other pictures ive seen, but im still coming up about an inch short of frame if i were to run the skirt straight down.. I wouldnt mind this, but there is no flat surface to weld to until you hit the frame. can anyone tell me what they did? my only idea is to angle the skirt toward the inside of the car, but that wont look right at all. any help would be appreciated.
|
You probably either need to widen the tub or just angle the skirt. i'm pretty sure most people on here had to angle it out a little to make it fit unless they have wide tubs with ugly corners near the shock tower haha