Im looking to get some for my custom chassis that utilizes some nissan spindles. But before i decide i need a couple measurements that PBM can not supply at this time. Anyone that has a pair off vehicle willing to take a couple measurements for me?
i need the max and minimum lengths, threaded all the way up, and all the way down
Front: Measured from bottom of camber plate to the center of the top bolt hole.
Rear: Bottom of pillow ball plate to center of the bottom coilover mount (part that bolts to knuckle).
SO this should mean two measurements per front and two per rear.
Thanks, Matt
For a quicker response
[email protected] for a quicker response please.