Thread
:
SLYDEurTYRE S14 Build...pic heavy
View Single Post
07-09-2010, 01:35 PM
#
2
bllabong89
Zilvia Junkie
Join Date: Jan 2010
Location: STL
Age: 36
Posts: 503
Trader Rating: (
7
)
I started taking off all of the suspension parts, brakes and hubs for my new brake and hub setup
My EVO8 Big brakes
and some extended studs
for my fresh POR-15 painted hubs
And after getting that stuff off, I found yet some more rust...Yay
I decided to just go ahead and go all out...so I pulled my front end and starteed pulling the engine harness and all the little stuff to pull the motor. I also pulled all of the interior out to finish the sound deadening removal and stitch welding.
Again, this is my first time so the stitch welds and everything isn't perfect but its going pretty well I think
I finished all of the inside besides the firewall and the trunk. Once the motor is out, I will most likely be tubbing the front and I will stitch weld everything up there too.
I pulled all of the wires out of the car.
And was left with this...
I will be doing a full tuck and fuse box relocation, battery in the back, full interior/exterior paint job, remove and redo undercoating, put good sound deadening back in and I am planning either a v8 or rb swap...This is all for today but I will update shortly.
lol. thats just funny lookin
Last edited by bllabong89; 07-21-2010 at
09:20 AM
..
bllabong89
View Public Profile
Find More Posts by bllabong89