Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - TX JGS SR20DET Top-Mount Turbo Manifold

realestvin7 · 08-20-2010, 11:39 PM

***$290 SHIPPED!***

This is a genuine JGS Precision turbo exhaust manifold. It allows the use of a T3 turbine side turbo on your SR20DET. This top-mount log-style manifold features very little internal volume so RPM boost threshold (spool up) will be lower in the rpm band than so-call TUNED EQUAL LENGTH turbo headers. Also good for street and drag racing where low rpm performance is a must. When done properly, up to 600HP is achievable (on a good flowing built DOHC 16v 4 cylinder engine). JGS sells just the kits to make this manifold for $200, and that doesn't include the mock-up, fabrication and welding to put it together. That also doesn't include machining the head, turbo and wastegate mounting surfaces after welding the assembly. This manifold has well over $400 in materials and fabrication invested, and also has heat wrap on it. I think my price is fair for a quality piece that WILL NOT BEND AND CRACK over time.

- $290 SHIPPED

- Andrew

I'm located in Denton, TX for local pickup. I accept paypal or money orders.

08-20-2010, 11:39 PM	#1
realestvin7 Zilvia Junkie Join Date: Jan 2010 Location: Denton, TX Posts: 345 Trader Rating: (1)	JGS SR20DET Top-Mount Turbo Manifold *$290 SHIPPED!* This is a genuine JGS Precision turbo exhaust manifold. It allows the use of a T3 turbine side turbo on your SR20DET. This top-mount log-style manifold features very little internal volume so RPM boost threshold (spool up) will be lower in the rpm band than so-call TUNED EQUAL LENGTH turbo headers. Also good for street and drag racing where low rpm performance is a must. When done properly, up to 600HP is achievable (on a good flowing built DOHC 16v 4 cylinder engine). JGS sells just the kits to make this manifold for $200, and that doesn't include the mock-up, fabrication and welding to put it together. That also doesn't include machining the head, turbo and wastegate mounting surfaces after welding the assembly. This manifold has well over $400 in materials and fabrication invested, and also has heat wrap on it. I think my price is fair for a quality piece that WILL NOT BEND AND CRACK over time. - $290 SHIPPED - Andrew I'm located in Denton, TX for local pickup. I accept paypal or money orders.