Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

HiPSI · 12-13-2003, 08:24 AM

i got a pair off of ebay for about $50 shipped. the front one sat a little low and hit the plastic harness cover for the injectors, but nothing a pry bar and a little finesse couldn't fix. i just had to bend the plate ends up a hair and it fit perfectly after that.

the rear one fit excellent right out of the box. quality/design on both is similar to most of the neuspeed bars i've seen around on other vehicles.

i've driven a car with the cusco D bar up front and that car was noticable stiffer in the frontend than my car is with a similar suspension setup, so yes there is a difference in performance for sure. but for $50/pair i can't complain

12-13-2003, 08:24 AM	#27
HiPSI Zilvia Junkie Join Date: Oct 2003 Location: Buford, GA Posts: 522 Trader Rating: (0)	i got a pair off of ebay for about $50 shipped. the front one sat a little low and hit the plastic harness cover for the injectors, but nothing a pry bar and a little finesse couldn't fix. i just had to bend the plate ends up a hair and it fit perfectly after that. the rear one fit excellent right out of the box. quality/design on both is similar to most of the neuspeed bars i've seen around on other vehicles. i've driven a car with the cusco D bar up front and that car was noticable stiffer in the frontend than my car is with a similar suspension setup, so yes there is a difference in performance for sure. but for $50/pair i can't complain __________________ SR motor set/clip $2500+, FMIC kit $700+, Downpipe $100+, 3" exhaust $500+, Misc install parts $100+, Shop labor for install $1000+ and you still only make 220rwhp for $5000 so what's so CHEAP about the SR swap again?