Hi, I am in the middle of re-sleeving and removing unneeded wires/plugs from my S13 sr20det harness.
The plugs in question are:
Boost Pressure Control Solenoid Plug
EAI AIV Control Solenoid Plug
Intake Air Sensor Plug
Tach Check Connector
#1 Coil Check Connector
#1 Coil Check Connector Resistor
Power Steering Pressure Switch Plug
Thermistor Control Amp Plug
And the small grey plug near the power plugs
I was wondering which of these plugs I could completely remove, seeing as I do not use any of them. When I remove them, can I just trace them back to the ECU Connector and De-pin them? Will any of them throw a CEL if removed?
I found this thread here and it has a picture of all the plugs in question.
http://zilvia.net/f/engine-tech/2930...ing-guide.html
(Thanks g6civcx)
But I just want to make sure before I start hacking stuff up.
Im hoping just to clean everything up. Thanks