Finally got to work on my car today , Yesterday I finished auto to manual s13 5 speed conversion installation into 95 s14.So i didnt have time to work on my car.Anyhow Today i finished preping outer metal skin from the donor car. I had to cut out a small portion of fender well in order to remove frame section at the bottom of door section.It is the only way to remove the the 3 layer metal section @ bottom . I will have to be extra carefull prepping this section on my car. I do not want to cut into frame .As I will only be removing outer skin.Hopefully keeping the structural frame intact.I will weld this piece back later .
This is the section that has to be removed
By
nismolvr at 2011-05-31
This is the piece I cut because the frame suppoort piece was welded under it , only way i could remove it.Height lenght 6 inches from bottom , I need to remember this info cause ,i dont want to cut frame .it will clear frame when i go to cut my cars out.
By
nismolvr at 2011-06-04
and its out
By
nismolvr at 2011-06-04