Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - PA 5-speed Transmission + Parts for Auto --> Manual Conversion!!

brudacille · 07-16-2011, 06:44 PM

I'm selling an auto to manual swap. I am not willing to part it out individually. I am not in serious need of money so don't try low balling me. I work full time and make great money. I decided to go a different route and no longer need these parts. I'm asking $450 Picked up... I'm located in York, PA 17406

5-Speed Transmission
5-Speed Transmission Crossmember
5-Speed Drive shaft
Flywheel
Clutch
Pressure Plate
Clutch Master Cylinder
Clutch Slave Cylinder
Clutch Pedal

Only thing you'll need is a shift knob, shift boot, metal circle bracket (used to hold the rubber boot to the trans tunnel), and a clutch line. I don't have the OEM hard clutch line because its junk. If I was doing the swap I would pick up an agency power Clutch Line for $30. Might cost you 40-50 to get these extra parts. I'll knock it off the cost if it concerns anyone that much...

07-16-2011, 06:44 PM	#1
brudacille Zilvia Junkie Join Date: Nov 2009 Location: York, PA Age: 40 Posts: 535 Trader Rating: (8)	5-speed Transmission + Parts for Auto --> Manual Conversion!! I'm selling an auto to manual swap. I am not willing to part it out individually. I am not in serious need of money so don't try low balling me. I work full time and make great money. I decided to go a different route and no longer need these parts. I'm asking $450 Picked up... I'm located in York, PA 17406 5-Speed Transmission 5-Speed Transmission Crossmember 5-Speed Drive shaft Flywheel Clutch Pressure Plate Clutch Master Cylinder Clutch Slave Cylinder Clutch Pedal Only thing you'll need is a shift knob, shift boot, metal circle bracket (used to hold the rubber boot to the trans tunnel), and a clutch line. I don't have the OEM hard clutch line because its junk. If I was doing the swap I would pick up an agency power Clutch Line for $30. Might cost you 40-50 to get these extra parts. I'll knock it off the cost if it concerns anyone that much...