|
Sarchastic a$$holes lol. This is the short version, as I remember it. Remove heat shield 10mm bolts, remove downpipe 14mm bolts, while your down there remove the 8mm hoseclamp from the oil return line, remove oil and water lines from block with a 17mm and a 19mm socket, fluid will leak, start removing 14mm bolts that hold the manifold onto the head, and finally have lots of fun removing the hose clamp with long needlenose pliers that holds the metal water feed line into the rubber hose line, behind the head. Lift the entire assembly out. When out, bend tabs down that are on the 4 nuts holding the T25 to the manifold, remove nuts and voila! Make sure you save those tabs! They are needed when re-installing.
Thank You and Good Night. I'll be here all week.
|