This should be a productive bump if my schematic is complete and actually works, I'm hoping a couple of the wiring gurus can confirm this. I'm very new to wiring so i may be very far off, but I took a shot at finishing my engine harness. Here is where I'm at. Now on the alternator I have nothing coming to terminal (L) at the regulator plug. This wire comes from the charge warning lamp, which receives power from the stock fuse panel and ground on the alternator if I'm not mistaken. Anything standing out that looks incorrect here?
This is for an s13 sr20 into and s13 using a custom switch panel. I have taken the 180sx schematic and translated everything to english. So this is the correct ecu pin out as well. Not just s13 sr20 "mocked up" on the english s14 diagram, so ghetto...