Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

huafist · 02-09-2012, 05:12 PM

Hey everyone,
I have a harness here that I'm having trouble with. I'm putting an RB25 in a 240, and the harness was in a bag when I got it. I did not get an ignitor, so I picked up a Z32 Ignitor and was planning on repinning the harness to fit it. The problem with that is, there are no flat 6 and 7 pin plugs on this harness. Even the plug on the COP harness does not match ; it's a square plug with 8 pins in it. Is there an intermediate harness that I didn't get, or something completely off?

I'm sure there's a simple explanation, as I'm new to all of this.

02-09-2012, 05:12 PM	#1
huafist Join Date: Feb 2012 Location: TN Age: 46 Posts: 2 Trader Rating: (0)	Wiring harness question Hey everyone, I have a harness here that I'm having trouble with. I'm putting an RB25 in a 240, and the harness was in a bag when I got it. I did not get an ignitor, so I picked up a Z32 Ignitor and was planning on repinning the harness to fit it. The problem with that is, there are no flat 6 and 7 pin plugs on this harness. Even the plug on the COP harness does not match ; it's a square plug with 8 pins in it. Is there an intermediate harness that I didn't get, or something completely off? I'm sure there's a simple explanation, as I'm new to all of this.