Quote:
Originally Posted by Flicktitty
I know i look like a broken record, but i found some new wheels that i might jump on. Just need some opinions. This will be going on a S13 COUPE.
17x9.5 +28 (rear)
17x8.5 +16 (front)
Looking to run a BFGoodrich 275/40/17 Drag radial on the rears.
Tire Diameter = 25.70 in.
Section Width = 11.00 in.
http://zilvia.net/f/chat/166563-maxi...ml#post3535638
This guy is running a 17x9.5 +12 with a 275/40/17 and about 3 degrees of camber.
So i am basing my figures off his car that these wheels i want should be 9/16 more into the wheel well. Whats your guy's thoughts on this?
Should work pretty "well" right? |
This is all going to depend on how low you run the car. You would need to pull the quarters slightly to run that setup if you want to run at a fairly low stance. If you look at my old setup I just posted, those are 275 on a 10" +44. You will be extending out an additional 10mm over the setup I had.... and mine would rub if I went any lower. I had rolled quarters just so you know. I wanted to go lower so I pulled the quarters and now run the 285.