FOR SALE: RB25DET MOTOR AND TRANSMISSION, COMPLETE UNCUT HARNESS, ECU, MAF, MODS AND PREP -
NOW PARTING OUT THE MOTOR!
I bought this RB25DET motorset with harness, ECU, and MAF from JDM of Miami. I went to check it out myself a
nd picked it up in my truck, they did a compression test on the motor before I picked it up. So on to the facts.
What is on the motor right now, and the parts I have.
ON THE MOTOR - NOW PARTING OUT THE MOTOR!
New - Nissan N1 Waterpump - Installed - $160 shipped!
New- OEM Idler and Tensioner pulleys - Installed - $70 shipped!
New- Greddy Extreme Timing Belt - Installed - $120 shipped!
Stock Turbo has very little shaft play, seems tight and ready to rock! Feels good!
Valve covers painted MKIV Supra Deep Jewel Green
All accessories, Coil-packs, Fuel Rail and Injectors, FPR, Stock intake manifold, throttle body, crossover pipe, stock BOV, stock idle air control hardware, Exhaust manifold, Stock Oil Cooler/FilterMount, Alternator, A/C compressor, Power steering pump, ALL THE PARTS ON A FULL RB25DET.
Dampened Crank Pulley - $55 SHIPPED!
Oil Pan -
SOLD! - $75 shipped
Oil Pick-Up Tube -
SOLD! - ^
Bellhousing to Block Brackets -
SOLD! - $35 shipped
Alternator -
SOLD! - $75 shipped
PARTS -
-Stock flywheel has been machined and is ready to go. I have the stock clutch also. -
-New - Primary and Accessory Dayco belts
-New - Valve Cover Gaskets (both intake and exhaust, RBs) - $35 SHIPPED!
-New - Nismo Thermostat(RBs, VGs), 21200-RS580 - $50 SHIPPED!
-New - Nismo Long Wheel Studs 60mm, 10-pack, 40222-RS025 - $55 SHIPPED!
-RB25DET Series 2 ECU - $110 SHIPPED!
-RB25DET Series 2 'Pink' MAF sensor, extremely nice condition - $75 SHIPPED!
-Beefy "RB25DET" Transmission, not RB20 trans. Shifts like new. -
SOLD! - $800
-Full, uncut engine harness -
SOLD! - Trade
-New, Never Run - Authentic Greddy Front Facing Intake Manifold, comes with a ton of new vacuum lines and vacuum fittings like a real Greddy piece should - These go for $1200 now.
- SOLD!! - $750shipped
Check out the pics!
Super JDM filter!
Stock turbo, downturn, O2 sensor, wastegate, compressor elbow
All pulleys (crank pulley, water pump pulley) and hardware not on the motor in these pictures are in boxes safe and sound. I thought I'd leave the timing covers off so you could see all of the shiny pieces underneath. I also have the stock intake manifold and stock clutch fan if you would like these with the motor, they are yours. I probably have stuff I have forgotten about also, just ask me about anything.
This stuff is in
East-Central Florida.
Please e-mail me at
[email protected] with any questions or offers.
Thanks for looking!
- JP