Quote:
Originally Posted by huffandpuff00
DO you think there would be enough room to fit a MVS, if the 44mm end was cut from the turbine housing and a 38mm flange was added. maybe even moving the flange closer to the housing! You stated that there was a little over 4" to the strut tower and the MVS(38) is 3.7" if i remember right. then the only other thing would be the top banjo fitting.
Maybe little hammer massaging to the tower could give a little room.
I really just don't like how clustered the 90 looks, if it could come off the housing like it was intended it would look cleaner!
|
It will still be a major PITA and need to get clocked or something. I wouldn't use a 2 bolt hard flange there either, due to constraints and fab ability of a dump pipe.