Quote:
Originally Posted by BoostinEuros
I don't think it can go down since the steering knuckle/shaft is in the way. They are a lot more beefy than S-chassis units. They do make joints to slim it down the assembly though.
|
well not exactly, but there is not enough room between the trany and the fir wall to run the down pipe straight down.
Quote:
Originally Posted by Eazy_tom
How big is the opening for that oil pickup?
Make sure its not to small or you could have a problem. Everything looks good though man.
|
im not sure but its not very small. and thank you ive been working really hard to complete this build and build it properly, but seems liek everyone has something against my work. but oh well.
Quote:
Originally Posted by StryfeS13
Yeah man, you need to figure out a better way to route that down pipe, and if there is no other way, you might have to move the motor a little forward..If the down pipe cant go straight down, is there a way you can maybe move the turbo forward in order to gain room to run a typical down pipe setup?
That looks like a disaster waiting to happen.
Really nice build though and i think this is a sick swap, but you gotta figure the dp out!
|
i know its dosent look very appealing, but im wrapping the down pipe so i should have no problem, i really wanted to run a typical down pipe set up but there was no way i could find the room. and thank you i was trying to do something different and new and exciting, im glad you like the build.
Quote:
Originally Posted by AsleepAltima
I have a question too - which line is that black line on top of the turbo? Water? You need to clock that turbo so the oil drain is pointing down.
|
the oil drain is at the bottom of the turbo, the top line is the oil feed, the right side is water drain and the left side is water feed.
Quote:
Originally Posted by tunermt
sick swap to say the least my friend  be sure to take your time with it, shame to see parts fabricated in a rush. Although sometimes you just have to make shit happen with what you have on hand! |
well im not in a rush, but the ass hole who bent the front section of the down pipe did a real shitty job and wouldn't do it over so i had to deal with it and use that pipe.