Quote:
Originally Posted by godzilla_753
So I went with the op's setup and now my line is leaking at the high pressure fitting going into the rack. Anyone have a solution to this? Its leaking more specifically at the 14mm to -6 adapter, I think its leaking because the threads are so short, only threads in half of what the original hard line there does. Anyone know what I can do to get it to stop leaking?
|
I remember I used teflon tape on the threads of my setup, there are lots of thread sealers you could use for a tighter fit
Also make sure that there isn't any pressure being exerted on the fitting, your line shouldn't pull or by tight at all. Try rearranging the geometry of your angled fittings to adjust this
just my 2cents