Quote:
Originally Posted by Danial
im confused where the part for "Earl's Fuel Injection Female O-Ring Seals" came from in this article
try this
Earl's 991954 Earl's AN to Metric Adapters
looks somewhat different than what you are using, if you need the male to female fitting i am sure that earls makes one for the same thread pitch and AN size
Did you use the crush washer in the correct place? I believe it is between the high pressure fitting into the rack
If you dont have enough threads then you need a different fitting, end of story. Make sure that the next fitting you get has enough threading, and make sure that it looks like what the OP used before you buy it |
Yeah I think you are a little confused. I went with the OP identical setup (except the stuff for the reservoir). So everything for the high pressure side is just like the OP's. Im lookin at the pictures of the op's setup and I dont see any washers for the rack side but I guess I can try that. The washer I have goes between the pump and the line..
And the link I listed is for an adapter from the factory hardline coming out of the rack to AN, if you reread my last post you'll see why I listed it.