Setup-
ASD 14" inch pull down with pass thru + the fittings they offer
Z32 rear backs
probably gonna run normal part store rotors/pads for now.
Haven't got around to getting lines yet but me and my buddy made little custom bracket which ASD sells but like 80 dollars and idk how/where it will fit so you your down to do a little fabbing/modding can save some money there.
We mount mine on the pass side center next to the dash(Look at pics) We Made the bracket and it was kinda loose so we add a backing plate to it which sits in the trans tunnel mounted with 2 bolts/washers/locking washers.
Will give you guys an update how hard it locks/how I like it.
Note:
I know it looks like it hits the dash but there is about 2-3mm of clearance and doesn't hit either when you pull down all the way and release it (let go) completly.
