|
Yea I'm sure I bled it correctly.
The rear main seal looked good, no leaking. As for the flywheel i Didnt get it resurfaced, It still looked good. Prob would have been smarter just to do it.
*But I was under the car today and had a buddy working the clutch, and its slipping B/C the fork doesnt have enough pressure pushing against the rod in the slave cylinder.
ex. Clutch in(down) works good, slave cylinder pushes the Fork perfect and shifting is easy. Release the clutch pedal(up) and the slave cylinder rod re-tracts but the fork pressure only pushes the rod about half the distance it should. resulting in the clutch not being fully engaged and slipping..
I'm sure i put all the springs on the fork and release bearing on properly.
Any Ideas?? Maybe the release bearing isnt pushing back easy enough? IDK
|