Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

89_SR20 · 01-01-2013, 05:02 PM

So I recently installed a Greddy Profec B II boost controller in my car. While trying to set it up I had it set to make factory boost Which is 7Psi. My boost gauge reads 7 pounds at WOT but the boost controller reads a warning of 37. Any help would be appreciated. Its a Redtop with Factory SMIC

Lines run as Follows. (Throttle Body)
Top left FPR Tee'd for the Boost Controller
Top right BOV
Bottom Boost Gauge.
Then line from actuator into COM port, NO line running to fitting on the cold pipe.

01-01-2013, 05:02 PM	#1
89_SR20 Join Date: Sep 2011 Location: Canada Posts: 28 Trader Rating: (0)	EBC reads way to much boost So I recently installed a Greddy Profec B II boost controller in my car. While trying to set it up I had it set to make factory boost Which is 7Psi. My boost gauge reads 7 pounds at WOT but the boost controller reads a warning of 37. Any help would be appreciated. Its a Redtop with Factory SMIC Lines run as Follows. (Throttle Body) Top left FPR Tee'd for the Boost Controller Top right BOV Bottom Boost Gauge. Then line from actuator into COM port, NO line running to fitting on the cold pipe.