I know everybody likes pictures...
Brake master, clutch, and PS res. are all in place, perfect spot top right for PS. That throttle cable isn't going to cut it...
Wish I could recall who made that heat shield. few years back some guy on here, its sweet.
Picked up this AN fitting, put it in the lathe, turned down the hex portion.
.
Drilled a hole in the waterneck and bam got that sucker welded in. also tapped it for aftermarket water temp.
swapped out the steering column bushing
New rack bushings, also made up some new lines since the others were beat to all hell.
We can also note at this point there's no motor....back out for paint!
During mockup I didn't have a clutch or flywheel in there. and only a few bell-housing bolts, so had to take care of that
This is an old ACT clutch of mine, its got some life left so just gonna rock it till it dies. HD pressure plate, 6 puck un-sprung.
I have seen it a couple times before and thought the idea of low mount PS pump was cool so one day I thought I'd fab up something. Took a couple tries but its pretty sturdy. Im not sure how much stress it will be seeing..?
Just for fun
I'll leave you guys with this...makeshift paint booth. 'Merica
