|
Been really busy lately, but I had a chance to measure this rod bearing and it is indeed the wrong size! Lesson learned. The machinist told me to order undersize 0.25, but changed his mind and said he would get them. This guy is a master, so I trusted him. Too much I guess!
Factory specs from FSM state undersize 0.25mm thickness should be 0.0769 - 0.0772 in. Mine is 0.0699 in.!
I remember why I didn't plastic gauge the rods, I kept messing up the line taking off the rod cap! Any good advice on doing this?
Thanks again everyone!
|