Quote:
Originally Posted by OrangeVirus1
Already Figured it out. My Rb20 Cuts If the maf hits more than 4.7 Volts. So I just used AEM to maf clamp it and Set the Maf Voltages to whatever I wanted and the Ecu see's what Volt I tell it and what RPM I tell it.
|
Does an RB have a factory map sensor too?
That is totally strange stuff for sure. Good to know though
Quote:
Originally Posted by OrangeVirus1
Also Could I fix my bouncy ride with let's say... 650?
|
The second half of the question is how low do you need to ride, and what do you do with the car?
If you don't need it super low, you can go with Koni yellow's and a spring setup of your choice. Also doesn't hurt to put caster/camber plates on it too
Koni Yellows Install on Nissan 240sx