Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - #Project180 a story involving rotary, type x, SR & 2j

2stepGoesPowPow · 05-02-2013, 01:32 AM

Dropped the welded diff that i had in my car.

Swapped in a Q45 diff for the better final drive & stronger axels.

Also replaced the passengers side knuckle because the thread that the bolt which holds the coilover to the knuckle was stripped out, also replace the rear lower control arm with brand new oem goodness.

Deleted the A/C condenser off the 2j

Since i sold my ebay seats i got an S14 driver seat to take the car to paint and do whatever else without having to mess up the new seats, a new un-cracked dash since mine has a few cracks from [Leung] 's parts car. heres the stuff packed into the daily.

So then i got S14 SE wheels AGAIN [i sold the ones i used to have] & put in a ton of hours sanding the car down until this was the end result.

I also power washed my engine bay, sprayed simple green everywhere, let it sit for about 20-30 mins and washed it all off. Here's before & after

Then the day finally came to take the car to the shop the begin the paint process.

05-02-2013, 01:32 AM	#15
2stepGoesPowPow Zilvia Addict Join Date: Sep 2011 Location: New York Age: 31 Posts: 949 Trader Rating: (10)	Dropped the welded diff that i had in my car. Swapped in a Q45 diff for the better final drive & stronger axels. Also replaced the passengers side knuckle because the thread that the bolt which holds the coilover to the knuckle was stripped out, also replace the rear lower control arm with brand new oem goodness. Deleted the A/C condenser off the 2j Since i sold my ebay seats i got an S14 driver seat to take the car to paint and do whatever else without having to mess up the new seats, a new un-cracked dash since mine has a few cracks from [Leung] 's parts car. heres the stuff packed into the daily. So then i got S14 SE wheels AGAIN [i sold the ones i used to have] & put in a ton of hours sanding the car down until this was the end result. I also power washed my engine bay, sprayed simple green everywhere, let it sit for about 20-30 mins and washed it all off. Here's before & after Then the day finally came to take the car to the shop the begin the paint process.