Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - No Start issue... Hoped it wouldn't come to this

Diehardsr20 · 06-17-2013, 09:59 AM

Ok so I have since gone back into it. Fixed both wires. I had also tested my body plugs and found I had no 12v switched with the ign on to my black/white wires to ecu pins 38/47. I tied it into the 12v from the black and red wire from the grey plug. ECU throws code 55 continuously now, except the part where I still have no spark at any of the plugs and only my number 3 & 4 injectors are firing now. Iv'e flipped the cas 180 out and then 180 out again to see if I may of had it backwards. It's still the same.

06-17-2013, 09:59 AM	#4
Diehardsr20 Join Date: Jun 2013 Location: Dexter, NM Posts: 37 Trader Rating: (0)	Ok so I have since gone back into it. Fixed both wires. I had also tested my body plugs and found I had no 12v switched with the ign on to my black/white wires to ecu pins 38/47. I tied it into the 12v from the black and red wire from the grey plug. ECU throws code 55 continuously now, except the part where I still have no spark at any of the plugs and only my number 3 & 4 injectors are firing now. Iv'e flipped the cas 180 out and then 180 out again to see if I may of had it backwards. It's still the same. Last edited by Diehardsr20; 07-10-2013 at 04:13 PM..