Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

SuperBlackS14 · 07-11-2013, 10:50 PM

Slave Cylinder... Right above the where the clutch line goes into the slave cylinder... Which is bolted to the side of your transmission with 2 14mm bolts.

FYI the bleeder screw is 8MM. I suggest a box ended wrench. Also make sure you run a line (rubber or plastic) from the bleeder into a "catch" can, coffee can, whatever so you don't have clutch/brake fluid everywhere.

Also, figured this goes without saying, but just in case you don't know, you can't reuse hydraulic fluid (brake/clutch fluid) after it's been through the system. Just don't do it.

07-11-2013, 10:50 PM	#14
SuperBlackS14 Zilvia Junkie Join Date: Sep 2011 Location: Albany, NY Age: 34 Posts: 381 Trader Rating: (4)	Slave Cylinder... Right above the where the clutch line goes into the slave cylinder... Which is bolted to the side of your transmission with 2 14mm bolts. FYI the bleeder screw is 8MM. I suggest a box ended wrench. Also make sure you run a line (rubber or plastic) from the bleeder into a "catch" can, coffee can, whatever so you don't have clutch/brake fluid everywhere. Also, figured this goes without saying, but just in case you don't know, you can't reuse hydraulic fluid (brake/clutch fluid) after it's been through the system. Just don't do it. __________________ "Power Is Nothing Without Control"