Finished the fuel lines, started routing the harness, gapped the new plugs, put the valve covers on, heatwrapped part of my harness by the radiator & the looped heater hose, Sunny also did most of the down pipe.
Tried to crank the car but nothing, Sunny jumped the starter and the car cranked slowly so i knew my starter was good. Added some grounds and tried to key start the car and nothing, checked fuses, nothing. Then i saw the clutch switch on the floor wasnt being pressed i think the clutch pedal bent away from it. So i pushed it with my hand and key started it and it cranked!!!, i was hyped.
Then i connected the fuel pump, added almost 2 gallons of e85, and tried cranking it again & it ran for about a second.
I need to figure out exactly where to connect my vacuum lines, adjust fuel pressure, & get a basemap and try again, also power steering needs to be finished, wideband bung welded on, exhaust crossover to cat-back, catch can set-up & a few other things..