Ok, finally I'm back in 'Murica! Spent the weekend tinkering around in the garage.
Got some goodies from SIKKY!
First I installed my Nagisa seat rails. I'm pretty sure they are the only side-mount sliders that will work with the Sparco Evo 2. I tried Buddy Club but they were not wide enough so I sold those on the forum and found these. Although, with these I need to relocate my trunk/gas tank handle. I still need the passenger side mount so if anyone is selling, let me know...
Enjoy the crappy phone pic.
Then I installed the Mishimoto radiator. I need to make some top mounts that fit better but since I still don't have an engine, the stock mounts will work for now to hold it in place.
Then I got to work on those rear subframe bushings. This job sucked! I did it by myself but I would recommend having at least one person help with this. Especially when your putting it back in. I wanted to have it powder coated but funds are low. Anyway, SIKKY subframe bushings installed.
Well, that's going to be it for a while. Funds are low. Now that the subframe bushings are done I can finally put some fluid in the break system. Keeping my fingers crossed that their are no leaks. Since I rebuilt EVERY caliper, there is a good chance I will have a mess on my hands...