[jhon-s13]

Originally Posted by Jtuned_andy

Ok let's bring this back up to the top. I thought I was golden when I finished everything but I guess not. Installed the DCC with all sensors required and door actuator with linkage. Unit powers up and cycles through all modes visually no problems minus some burned out bulbs. Hot/Cold actuator moves, or at least I thought it was moving when I put my hand under the heatercore. Blower motor does not work at all with fan selection. I have the JDM blower motor speed control but USDM thermostat control amp.

When I enter diagnostic mode:

**--** TEST 3, codes (31) (32) (34) (35) (36) see below
**--** TEST 4, the actuator doesn't move when cycling through the vents. It worked before, I haven't messed with that part of the harness and now it doesn't work.

Here are pictures of each step of wiring I did according to driftenthusiast's writeup.

This is my first step. Red wire is for "Constant +12v power" to DCC harness. Blue wire is for "Ignition on +12v power". All wires have either been de-pinned and soldered or re-pinned.
















Here I have left the JDM relay attached to digital control harness and removed USDM relay.

can you update the picture because i can see plz and i have one question about the relay stock and jdm sub harness did you desconect the stock relay o what did you do whits the relay's???