Quote:
Originally Posted by Chaluska
never solder in the engine bay.. always use crimps
engine = hot. solder melts in heat.
|
If your engine gets hot enough to melt the solder, I believe you have another issue. Would have to get extremely hot for it to melt the solder unless you use cheap crap that melts with light heat.
Also, to the OP, you may want to look at a diagram to see where all the wires for the starter go too so you know which start the starter and which may not be as important. You can also try using a remote starter switch, turn the key to ON position and try turning over the engine. In theory, should start unless you are missing more connectors and wires. Go over everything you did and make sure there are no missing connectors. I know you said it starts up fine so really just sounds like you didnt connect something correct. Tripple check it all and make sure it is all correct.