Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

SirReptar · 04-17-2014, 01:59 PM

So I was trying to install the drive shaft on my 89 240sx, and when I go to put the support bracket that goes around the center bearing, it's not lining up. At all. Is there a trick to doing this that I'm not getting? I have the drive shaft jacked up and into place in the diff and tranny. I'm not very experienced with working on cars either, bit of a noob.

04-17-2014, 01:59 PM	#1
SirReptar Join Date: Sep 2013 Location: Arizona Age: 29 Posts: 39 Trader Rating: (0)	Drive shaft support not lining up So I was trying to install the drive shaft on my 89 240sx, and when I go to put the support bracket that goes around the center bearing, it's not lining up. At all. Is there a trick to doing this that I'm not getting? I have the drive shaft jacked up and into place in the diff and tranny. I'm not very experienced with working on cars either, bit of a noob.