Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - S14 SR leaning out after battery drain. Help needed

Bullett · 06-27-2014, 04:39 PM

Like a dummy I left my lights on yesterday at work and it drained my batt. Well after jumping it, the engine would not shut off when I turned the key off, also the turbo timer had no power while every other component did. So after leaving the battery unhooked for about 10 min, I hooked it back up and everything was fine. Took it on a test drive and things were fine. This morning took it out and the wide band was reading at 13-14 at WOT. hasn't done that all week. My fuel pressure is at 41psi and low boost pressure is set at 9 psi. NO clue what changed. after draining my battery Mods are: factory T28, Wally 255, Tomei Type s afpr with gauge, stock injectors, stock maf, greddy Fmic, AEM Uego, profec B (9psi lo 13.5 hi), greddy turbo timer. The AFPR and injectors were installed just last weekend, but I have no leaks and pressure is good. What are everyone's thoughts?

06-27-2014, 04:39 PM	#1
Bullett Leaky Injector Join Date: Jan 2014 Location: Valdosta GA Age: 42 Posts: 133 Trader Rating: (3)	S14 SR leaning out after battery drain. Help needed Like a dummy I left my lights on yesterday at work and it drained my batt. Well after jumping it, the engine would not shut off when I turned the key off, also the turbo timer had no power while every other component did. So after leaving the battery unhooked for about 10 min, I hooked it back up and everything was fine. Took it on a test drive and things were fine. This morning took it out and the wide band was reading at 13-14 at WOT. hasn't done that all week. My fuel pressure is at 41psi and low boost pressure is set at 9 psi. NO clue what changed. after draining my battery Mods are: factory T28, Wally 255, Tomei Type s afpr with gauge, stock injectors, stock maf, greddy Fmic, AEM Uego, profec B (9psi lo 13.5 hi), greddy turbo timer. The AFPR and injectors were installed just last weekend, but I have no leaks and pressure is good. What are everyone's thoughts?