ill add on to this aswell since i just got done with the whole swap!
heres what i used:
trans- got from lswans garage and is a late soarer trans.
*MAKE SURE YOU GET SHIFTER IF ITS 2ND GEN SOARER R154 BECAUSE THEY ARE EXTINCT. i had to search 3 months until i found a remote r154 shifter in new Zealand.
clutch line from enjuku
gear oil- redline
rad- KA VS SR. IF YOU go ka then you have to cut waterneck some.
if you go sr (i did) then you have to make a custom hose due to length or just have a welder change the neck for the radiator over.
fans- just went with two 12 inch i believe ebay fans and they barely fit (one is unlevel since i didnt want hitting the pulley.
drive shaft- shaft masters aswell and fits perfect
MOTOR- 1JZGTE VVTI chaser from lswans garage.
Harness is shorter on these so expect a bit more pay when getting harness done from someone experienced since they must be extended quite abit.
fuel lines- just got some rubber hose from sjop in town along with all my bolts and stuff.
IMPORTANT ** throttle body may have to be cut to fit ic coupler as it was for me, which is ok.
(in picture cut black and weld the pink together)
heater hoses- you will have to get creative. GOOD LUCK getting the back one (behind the head) off as mine has to have been on there for 20 years it seems.
downpipe- i got a cx racing one off my buddy and it fits good.
as far as new parts
i ordered a gasket kit from champion toyota in texas (researched) and was the cheapest as it was about 300 i think. YOU WILL NEED PART NUMBER
and then i got a water pump, new timing stuff, and obviously gaskets and seals.
mounts- ebay mounts...they fit ok but we had to dill new holes as the ones made were stupid.
***trans mount wont work with regular r154 2nd gen mount. YOU MUST get the 1jzgte mark 3 supra r154 mount to work.
1jzgte engine mounts- mine sucked....they broke midway on transfer so i had to use hockey pucks...buy good ones.
harness- i searched and searched and went with justin collins over at qfab...and so far its been ok. i got the harness back and havent got it diagnosed but it wont start so as soon as i get that figured out then ill decide how it went.
ILL ADD AS I GO.
engine rubber mounts broke in this pic
