|
You will need the lower harness for:
1. oil pressure switch
2. alternator wire (im only saying maybe because it depends on how the vq has it set up)
3. starter signal wire
The plug under the dash that the engine harness connects to you will need:
1. Ground
2. water temp
3. rpm
4. theres powers and start signal wires there i believe
5. speed sensor signal
the grey and brown plugs that the engine harness connects to the chassis near the battery you will have:
1. always hot power
2. ign on power
3. grounds
4. i honestly cant remember the rest
im letting you know get ALL of you info first of the 240 and vq wiring and then make a table of which wires will be soldered where. this alone will take about 3 full nights. then go ahead and lay everthing out in the car so you know you have it routed the way you want and then solder away.
I wired my ls1 in my s13 and after having everything planned out i still hit a few bumps on the road. it took me about a week to complete but i saved myself a lot of money and wait from trying to get one at wiring specialties.
|