Got a little more done last night
Finalized some wire routing, plugged in more sensors. Made sure I had enough grounds for the motor. This is something that has always slowed me down on start ups.
1 from the coil pack harness to the head.
1 on the head to the firewall.
2 on the intake manifold (either side) to the chassis and firewall.
1 from the block tranny area to the chassis.
1 from the battery to the chassis.
1 from the fuse box to the chassis. etc (if I am missing any please let me know)
Filled the car will oil.
Installed the fan.
Installed the rad and shroud, which I modified a little, so I can pull it out easier.
Bolted in the power steering cooler and lines.
I went to install my tranny cross member last night and the bolt holes are not lining up properly. I am going to level the car back out and look at it again.
Front core support mocked up. I need to find some plates and bolt the top together properly.
Next on the list will be to install the intercooler and finalize some piping revisions.